how to adjust low speed idle on fuel injected harley road king

how to adjust low speed idle on fuel injected harley road king

how to adjust low speed idle on fuel injected harley road king

Hello  on the post “how to adjust low speed idle on fuel injected harley road king” on website negarinfo  .

If you want to know more, please be with us to the end.

On fuel injected Harley-Davidson’s there is no direct adjust ment possible. Unless you have Harleys electronic diagnostic computer or a tuner dongle, Harley or aftermarket. And even then there may not be much at all.

Older carbureted Harleys can be adjusted using the idle stop screw that pushes directly on the throttle stop to set the lowest speed for idle. Most carbureted Harleys should be set for 1000–1100 rpm, in European markets that number is approximately 1250 rpm.

How do I adjust the idle on fuel injection on my 2003 FLHRI ?

Find out why it is out and fix the problem which will reset the idle to what it should be. The idle set screw is a special one that requires a special tool to move BECAUSE it should never need to be adjusted as the IAC and the computer set the idle and it it is out of specs it is because something other than the position of the idle set screw is out of whack and needs to be fixed. The base problem may or may not set a DTC dep3ending on what is out of whack BUT it is always a good idea to display any codes if there are any as a stritng point to diagnosis.

more :  touch typing is an example of a way that technology is improved by new
how to adjust low speed idle on fuel injected harley road king
how to adjust low speed idle on fuel injected harley road king

Can you adjust idle speed on fuel injected Harley Davidson?

When a bike possesses a carburetor, you can easily adjust idle speed according to your preference with an idle screw. But for an electronic fuel-injected motorbike, it is altogether a different process. Hence, many motorbikes riders face problems when it comes to fuel injection installed by Harley Davidson. But you don’t need to worry.

MORE TO READ:

What should the idle range be on a Harley Davidson?

Generally, any motorbike of Harley Davidson requires an idle range, which should be between 950 and 1000 RPM. Always try maintaining this range while for a fuel-injection installed Harley Davidson. Otherwise, the bike could suffer an insufficient charge of the battery too.

Why does my Harley Davidson stall when I idle?

It always starts easily when cold and idles well, but after a few minutes, if I’m idling awhile to get out of my driveway, the idle will fall and the engine will threaten to stall. If it does stall it’s hard to get started again, I have to give it a little throttle to get it to start and stay running.

What’s the idle on a fuel injected motorbike?

Most Fuels injected motorbikes have high idle, which many motorbike riders dislike. In general, the Fuel-injected idle does not get altered as the manufacturing factory sets the appropriate idling and controls electronically in the EFI system.

more :  shortest model
fuel injected harley road king
fuel injected harley road king

What causes the idle speed to go up or down?

The idle air control valve is programmed to regulate and maintain the engine idle speed at a constant rate. If the valve fails or has any issues it can cause the idle speed to be thrown off. This may result in an unusually high or low idle speed, or in some cases a surging idle speed that repeatedly climbs and falls. 2. Check Engine Light comes on

Is the idle speed motor on my 99 ultra bad?

I have a 99 Ultra with MM Injection. When I bought the bike 4 years ago the cold start/idle was terrible. Being in the car business it was not too difficult to diagnose as a bad idle speed motor. It actuated but once it touched the lever it would not move it.

What are the symptoms of a bad idle control valve?

$0.00 1 Irregular idle speed One of the most common symptoms commonly associated with a problematic idle air control valve is irregular idle speed. 2 Check Engine Light comes on Another symptom of a potential issue with the idle control valve is an illuminated Check Engine Light. 3 Engine stalling

fuel injected
fuel injected

What kind of Idle did my bike have?

My bike had an uneven idle, would stumble & cough at low RPMs (like turning a tight corner at slow speed) and generally ran OK, MOST of the time.

When to replace the idle air control motor on a Harley?

Direct replacement for Harley p/n 27658-06 on 2007+ EFI models except XL Sportster and 08+ TBW touring models.* When fuel injected Harley motorcycles begin to experience a rough or high idle, or a hard start condition, often this is a result of a faulty Idle Air Control ( IAC) or MAP sensor.

more :  tp-20 a boater would use a tide table for what type of information

 

Leave a Reply

Your email address will not be published. Required fields are marked *